Sennheiser Set SET 820 Instruction Manual

BedienungsanleitungInstructions for useNotice d´emploiInstrucciones para el usoSet 820Set 820-9_515831_0206_Sp4.book Seite 1 Dienstag, 15. August 20

8Charging the batteryPlace the receiver into the transmitter’s charging compartment, with the operating control at the front. The left LED on the tran

9Adjusting the volumeAdjust the receiver’s volume with the operating control. If you are not using the stethoset receiver, store it in the transmitter

10Changing the transmission channelTo avoid interference caused by the simultaneous operation of several transmitters, select a different channel on e

11Adjusting the receiver channel First turn on the transmitter (see section “Where to place the transmitter”). Then put on the stethoset receiver - as

12Additional informationThe audio transmission technology used with this unit is basically that of a radio. According to today’s scientific knowledge,

13AccessoriesOnly use original Sennheiser spare parts and accessories. The following accessories are available from your authorized dealer:Rechargeabl

14BA 151 rechargeable batteryBy using a spare battery, you can use the stethoset receiver for more than four hours of continuous operation. Always sto

15RR 820 stethoset receiverOne transmitter can transmit to several receivers. Additional RR 820 receivers are available from your authorized dealer.RR

16If problems occur...- Are all jack plugs connected correctly?- Are the receiver and sound source turned on and is the volume of the- receiver and so

17Additional information for hearing aid acousticiansAdjusting the earbow pressureLoosen the screw at the rear of the stethoset receiver. Move the scr

Set 820-9_515831_0206_Sp4.book Seite 2 Dienstag, 15. August 2006 2:18 14

18Adjusting the max. volume:Potentiometer turned fully counterclockwise 0 dBPotentiometer turned fully clockwise 125 dBAdjusting the bass response:P

19Technical dataModulation FM, stereoCarrier frequencies see type plate at the base of the transmitterAF frequency response 40 Hz ... 15 kHzS/N

20Manufacturer declarations CE Declaration of ConformityThis equipment is in compliance with the essential requirements and other relevant provisions

21Statement required by FCC rules Part 15 and RSS 210This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.Operation

22- Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment to an outlet on

Set 820-9_515831_0206_Sp4.book Seite 1 Dienstag, 15. August 2006 2:18 14

Sennheiser electronic GmbH & Co. KG30900 Wedemark, GermanyPhone +49 (5130) 600 0Fax +49 (5130) 600 300www.sennheiser.com Printed in Germany

1Set 820Thank you for choosing Sennheiser! Over 60 years of accumulated expertise in the design and manufacture of high-quality audio equipment has ma

2WARNING: Volume up? - No!When people use headphones, they tend to choose a higher volume than with loudspeakers. However, if your hearing has deteri

3Delivery includes The Set 820 consists of the following components and accessories:- Stethoset receiver RR 820- Transmitter(charging unit) TR 820-

4Connecting the transmitter (charging unit)The rear of the transmitter is fitted with two audio inputs: A socket (LINE) for connectionto the LINE OUT

5Connect the power cable to the POWER socket on the transmitter. Plug the power supply into a household electrical outlet. Pull the power supply unit

6Where to place the transmitterChoose a suitable place near or on top of your hi-fi system or TV set.Do not place the transmitter close to metal objec

7Using the stethoset receiverWhen putting the stethoset receiver on, make sure the operating control is pointing downwards and the letters are at the