Sennheiser W300 IEM User Manual

SR 350 IEMInstructions for useW 300 IEMew300_350_IEM_INT.book Seite 1 Freitag, 7. März 2008 8:55 08

8EK 300 IEM G2 stereo receiver    Operating controls LC display panel Headphone output (PHONES), 3.5 mm jack socket  Antenna

9Indications and displays on the transmitterModulation display The level display for audio signal “AF” shows the modulation of thetransmitter.When the

10“MUTE” displayThe “MUTE” display  appears on the display panel when the RF signal of thereceived transmitter is too weak.“PILOT” displayThe “PILOT”

11Preparing the devices for useSR 300 IEM G2 transmitter/ SR 350 IEM G2 twin transmitterFitting the device feetTo ensure that the transmitter cannot s

12Rack mounting the SR 350 IEM G2twin transmitterThe rack mount “ears” are already fitted to the twin transmitter on delivery.To mount the twin transm

13When mounting only one transmitter into a rack, use the blanking plate instead of the second transmitter. To mount only one transmitter into a rack

14The antenna mounts consist of:y 2 BNC extension cables (screw-in BNC socket to BNC connector )y 2 washers y 2 nutsy 2 antenna holders (GA 3030 AM

15 Connect the two BNC connectors to the BNC sockets  on the twintransmitter. Slide the twin transmitter into the 19’’ rack. Resecure the rack mo

16Connecting the transmitter to the mainsBoth transmitters have no mains switch. To connect the transmitter to the mains: Pass the cable through the

17Service interface/ connection to the NET 1 network systemThe service interface (DATA A/B)  is only required for servicing purposes.In addition, the

ew300_350_IEM_INT.book Seite 44 Freitag, 7. März 2008 8:55 08

18Connecting the headphones For monitoring purposes, connect the supplied earphones or anySennheiser stereo headphones with 3.5 mm stereo jack plug t

19Adjusting the volumeYou can adjust the volume at the headphone output on both the transmitterand the receiver. Use the volume control  or  to adj

20The operating menuTo ensure intuitive operation of both transmitter and receiver, the operatingmenus have been largely standardized. As a result, ad

21Overview of menusWorking with the operating menuBy way of example of the “Tune” menu, this section describes how to use theoperating menu. After swi

22Getting into the operating menu Press the SET button to get from the standard display into the operatingmenu. The last menu selected flashes on the

23Operating menu of the stereo transmitterSETSETSETSETSETCurrent channel and corresponding frequencyCurrent frequency on the selected channel  / :

24SETSETSETSETName GUITARBank 3Security check   / : No, Yes"reset"= Yes: SET: Transmitter loads factory-preset def

25Operating menu of the stereo receiverSETChanging the channelSTOREDCHAN 1.01B.CH 1.12B.CHSETCurrent channel or frequency  / : Channel 01...12SET:

26SQELCHHI--BSTSET  / : OFF, ON SET: Stores the setting SETSTOREDSTOREDLTDSET  / : OFF, ONSET: Stores the setting LTD.OFFOFF LTD. ONON HB.OFFOF

27NAMEPILOTActivating/deactivating the pilot tone transmissionSETPilot tone transmission activated or deactivated  / : ON, OFFSET: Stores the setti

1ContentsImportant safety instructions ... 2The ew 300 IEM G2 syst

28Adjustment tips for the operating menuSwitching between channel banksBANKBankVia the “Bank” menu, you can switch between the nine channel banks of t

29 Select “START” and confirm your selection by pressing the SET button.After the scan is completed, the number of free channels is displayed.Pressin

30Stereo/FOCUS selection (receiver only)ST-FOCVia the “ST-FOC” menu, you can switch between stereo and FOCUS operation. In both operating modes, the t

31Selecting the standard displayDISPLYDisplayVia the “Display” menu, you can select the standard display.SR 300 IEM G2 transmitter/SR 350 IEM G2 twin

32Entering namesNAMENameVia the “Name” menu, you can enter a freely selectable name for thetransmitter and the receiver. You can, for example, enter t

33Stereo/mono selection (transmitter only)Mode Via the “Mode” menu, you can switch the transmitter between mono andstereo operation. Note:Connect any

34If a problem occurs ...Error checklistIf a problem occurs that is not listed in the above table or if the problem cannot be solved with the proposed

35Recommendations and tips... for the EK 300 IEM G2 receivery The antenna should hang freely and be at least 1 cm away from the body.The antenna must

36Additional informationHDX noise reductionProgress you can hear:The evolution wireless G2 series is equipped with HDX, the Sennheiser noisereduction

37SquelchPilot tone squelchThe transmitter adds a 19-kHz pilot tone to the audio signal. The receiverchecks incoming audio signals to see if the pilot

2Important safety instructions1. Read these instructions.2. Keep these instructions. Always include these instructions when passingthe devices on to t

38SpecificationsSystemIE 4 earphonesEK 300 IEM G2 receiverRF characteristicsModulation wideband FM stereo, MPX pilot toneFrequency ranges 518–554, 572

39SR 300 IEM G2 transmitter/SR 350 IEM G2 twin transmitterType approvals Connector assignmentRF characteristics SR 300 IEM G2 SR 350 IEM G2RF output p

40Accessories and spare partsCat. No. Accessory/spare part009823 GA 2: 19’’ rack adapter009912 AM 2 (for SR 300 IEM G2):Antenna mount for mounting ant

41Manufacturer DeclarationsWarrantyThe original Sennheiser product you have purchased is covered by a warrantyof 24 months. The warranty period begins

42CE Declaration of ConformityThis equipment is in compliance with the essential requirements and otherrelevant provisions of Directives 1999/5/EC, 20

ew300_350_IEM_INT.book Seite 44 Freitag, 7. März 2008 8:55 08

Sennheiser electronic GmbH & Co. KGAm Labor 130900 Wedemark, GermanyPhone +49 (5130) 600 0 Printed in GermanyFax +49 (5130) 600 300 Publ. 03/08www

3Hazard warnings on the rear of the transmitter (SR 350 IEM G2 only)The label shown on the left is attached to the rear of the transmitter. Thesymbols

4Intended use of the devicesIntended use of the ew 300 IEM G2 series devices includes:y using the devices for professional purposes,y having read thes

5The channel bank systemThe ew 300 IEM G2 systems are available in six UHF frequency ranges with 1440 transmission/receiving frequenciesper frequency

6Overview of operating controlsStereo transmitter – front view (SR 350 IEM G2 twin transmitter)Operating controls Rack mount “ears” (preinstalled wit

7Stereo transmitter – rear viewOperating controls on the SR 350 IEM G2 twin transmitter 3-pin IEC mains socket Cable grip for power supply DC cable