Set 810BedienungsanleitungInstruction ManualNotice d´emploiIstruzioni per l´usoInstrucciones para el usoGebruiksaanwijzingBruksanvisningset 810_93286_
9EnglishAdditional informationThis system uses infrared light which is emitted by the transmitter and received by the stethoset receiver. Please note
10EnglishWARNING: When people use headphones, they tend to choose a higher volume than with loudspeakers. However, if your hearing has deteriorated an
11EnglishAccessories Only use original Sennheiser spare parts and accessories. ATTENTION: Components from other manufacturers (e.g. for power supply o
12EnglishBA 151 rechargeable batteryBy using a spare accupack, you can use the stethoset receiver for more than four hours of continuous operation. Al
13EnglishRI 810 additional stethoset receiver One transmitter can transmit to several receivers. Additional RI 810 receivers are available from your a
14EnglishIf problems occur...- Are all jack plugs connected correctly?- Are the receiver and sound source turned on and is the volume of the receiver
15EnglishAdditional information for hearing aid acousticiansAdjusting the earbow pressureLoosen the screw at the rear of the stethoset receiver. Move
16EnglishAdjusting the max. volume: Potentiometer turned fully counterclockwise 0 dBPotentiometer turned fully clockwise 125 dBAdjusting the bass resp
17EnglishTechnical DataSystemModulation FM, stereoCarrier frequencies 2.3 / 2.8 MHzAF frequency response 40 Hz ... 15 kHzS/N ratio 60 dB A rmsTran
18EnglishManufacturer declarationsCE Declaration of ConformityThis equipment is in compliance with the essential requirements and other relevant provi
1EnglishSET 810Thank you for choosing Sennheiser! Over half a century of accumulated expertise in the design and manufacture of high-quality audio equ
Sennheiser electronic GmbH & Co.KG30900 Wedemark, GermanyPhone +49 (5130) 600 0Fax +49 (5130) 600 300www.sennheiser.comPrinted in Germany Publ. 04
2EnglishDelivery includes The Set 810 consists of the following components and accessories:- Stethoset receiver RI 810- Transmitter (charging unit) TI
3EnglishConnecting the transmitter (charging unit)The rear of the transmitter is fitted with two audio inputs: A socket (LINE) for connection to the a
4EnglishWhere to place the transmitterPlace the transmitter so that the infrared light beam is pointed directly at the receiver, i.e. there should be
5EnglishUsing the stethoset receiverWhen putting the stethoset receiver on, make sure the operating control is pointing downwards and the letters are
6EnglishAdjusting the volumeAdjust the receiver's volume with the operating control. Make sure your hand doesn't cover the operating control
7EnglishTurning the automatic compression system onUse the COM switch (compression) at the rear of the transmitter to turn the automatic compression s
8EnglishCharging the batteryPlace the receiver into the transmitter's charging compartment, with the operating control at the front. The left LED
Comments to this Manuals