Mounting and installing the products
18 | SpeechLine IS microphone series
Mounting surface-mounted boundary layer
microphones, microphone buttons, switch boxes:
table | lectern
Drilling a hole through the surface of the table or lectern
Once you have chosen a position fo
r the product (see page 16):
왘 Drill a hole with a diameter of 2
5 mm through the mounting surface
(plate thickness: 10 mm - 65 mm).
Mounting the MEB 102 (-L) | MEB 104 (-L) boundary layer microphones
1 Slide the first rubber ring o
ver the threaded bolt of the microphone and
then insert the microphone into the drilled hole.
2 Orient the MEB 104 and MEB 104-L microphones towar
ds the speaker.
Slide the second rubber ring over the threaded bolt and tighten the hex
nut.
Mounting the MAS 1 microphone button
1 Slide the first rubber ring over the
threaded bolt of the microphone
button and then insert the microphone into the drilled hole.
2 Slide the second rubber ring over the threaded bolt and tighten the hex
nut.
MEB 104MAS 1
MEB 104
MAS 1
Comments to this Manuals