Sennheiser SpeechLine Instruction Manual Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 47
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
Connecting the products
28 | SpeechLine IS microphone series
Connecting products via the logic function
Once you have established the audio connection (see previous chapter),
you can connect the products of the IS microphone series featuring a logic
port (shown on the left) to the DSP.
The logic port passes on status information on the microphone button
(microphone button pressed/not pressed) to the DSP. Via the logic output
of the DSP, you can additionally control the status of the signal light ring
of the microphone button.
The logic output also allows you to integrate and control several MAS 133
inline switch boxes in a system.
The following chapters provide
A) information on how to connect the MAS 13
3 inline switch box to a DSP
B) information on how to connect microphones
C) an example installation for the Se
nnheiser TeamConnect system
A) Connecting the MAS 133 inline switch box to the DSP via the logic
function
The way you connect the MAS 133 inline s
witch box determines which
information is passed on to the DSP.
Use a 2-wire cable (Ø 0.14–0.5 mm
2
) to connect the inline switch box
to a GPIO port or logic port of the DSP.
Lay all cables so that other persons cann
ot trip over them and injure
themselves.
Observe the connection inst
ructions in the instruction manual of your
DSP.
MEB 114-S
MAT 153-S
MAS 133
MAT 133-S
MAS 133
Logic port Function
Passes on status information on the microphone button –
button pressed/not pressed– to the DSP.
Passes on microphone status information – microphone
activated/muted – to the DSP.
Switch
signal
out
DSP
control
MAS 133
DSP
logic
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 46 47

Comments to this Manuals

No comments