Connecting the products
SpeechLine IS microphone series | 29
B) Connecting microphones to a
DSP with logic function
To establish a logic connection in addition to the audio connection:
왘 Use a 3-wire cable (Ø 0.14–0.5 mm
2
) to connect the microphone or the
table stand to a GPIO port or logic port of the DSP.
왘 Lay all cables so that other persons cannot trip over them and injure
them
selves.
왘 Observe the connection inst
ructions in the instruction manual of your
DSP.
왘 Set the slide switch for setting the behavior of the microphone button
to ON in order to activate the “DSP remote mode”.
I
n “DSP remote mode”, the microphone is permanently on and is muted
or activated via the DSP. The microphone thus permanently provides a
reference signal for AEC algorithms in the DSP.
DSP
logic
Logic in
Ground
Logic out
MAT 133-S MAT 153-SMEB 114-S
ON PTM PTT ON
OFF
MAT 133-S
MAT 153-S
MEB 114-S
Comments to this Manuals