Sennheiser Freeport User Manual download pdf (Page 9)

Connecting the microphone/instrument cable

The audio input is designed for the connection of both the ME 2 clip-on

microphone and instruments (e.g. guitars).

왘 Connect the 3.5 mm jack plug from the microphone/instrument

cable to the 3.5 mm jack socket .

왘 Check the setting of the MIC/INST slide switch  which allows you

to switch between microphone and instrument operation. If

necessary, readjust the setting.

왘 Use the GAIN control  to adjust the transmitter sensitivity so that

the receiver receives a good audio signal (no distortion and no

background noise).

Attaching and positioning the microphone

Use the microphone clip to attach the ME 2 clip-on microphone to

clothing (e.g. tie, lapel). Conduct the microphone cable so that noise due

to friction is avoided and make sure that the antenna and the cable do

not cross. The omni-directional microphone picks up sound equally from

all directions. However, it should be attached as close as possible to the

sound source.

Attaching the bodypack transmitter to clothing

왘 Use the supplied belt clip  to attach the bodypack transmitter to

clothing. Make sure that the antenna is at least 1 cm away from the

body and is not kinked.

Switching the bodypack transmitter on/off

왘 Press the ON/OFF button  to switch the bodypack transmitter on

or off. If the bodypack transmitter is switched on, the red LED 

lights up.

Note:

Remove the battery when the transmitter will not be used for

extended periods of time.

Selecting and changing a channel

왘 Switch off the transmitter before you change the channel.

왘 Use a small screwdriver to set the channel selector switch  to the

desired channel. You can switch between four different channels.

When you switch on the bodypack transmitter again, it will transmit

on the new channel (see “Selecting a channel” on page 24).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

Sennheiser Freeport User Manual Page 9