Sennheiser MM400 Instruction Manual download pdf (Page 13)

Putting the MM 400-X into operation

12 | MM 400-X

Pairing the MM 400-X with an audio source

When switching the headset on for the first time, it will automatically go

into pairing mode. The headset is waiting to be paired with a Bluetooth

enabled device.

왘 Press the Master button 햶 and keep it pressed until the LED 1

alternately flashes blue and red.

왘 On your audio source, activate the Bluetooth function “Add a new

device”.

왘 Proceed as described in the instruction manual of the audio source.

If a suitable audio source is found, the devices will exchange device identi-

fication information. The LED 1 flashes 3 times blue and you hear an

ascending beep. The devices have identified each other and the headset is

paired with the audio source.

If no device is found within approx. 5 minutes, the LED 1 flashes

3 times red and you hear a descending beep. The headset will then try for

3 minutes to connect to one of the up to 8 previously paired audio sources.

If this fails, the headset automatically switches off after 60 minutes.

왘 In this case, repeat the necessary steps to pair the headset with the

audio source again.

Disconnecting the Bluetooth connection

The Bluetooth button 쐏 is backlit, indicating the current setting. The

backlighting goes off after a short time to conserve energy.

왘 Press any button on the headset to display the current setting of the

Bluetooth function.

To disconnect the Bluetooth connection to the audio source, you can

switch off the headset or the Bluetooth function. This setting is retained

until the Bluetooth function is switched on again.

To switch the headset off:

왘 Press the Master button 햶 and keep it pressed until the LED 1

flashes 3 times red.

You hear a descending beep. The Bluetooth connection is automatically

deactivated. The headset switches off.

To switch the Bluetooth function off:

왘 Press the Bluetooth button 쐏 and keep it pressed until the LED 1

flashes 3 times red. You hear a descending beep.

The Bluetooth button 쐏 goes off. The Bluetooth function is switched

off.

왘 Make sure that your headset is switched off (see “Switching the

MM 400-X on/off“ on page 14).

PIN code

When the audio source prompts for a password or PIN code, enter

the default PIN code “0000”.

쐏

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments

Sennheiser MM400 Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Mobile headsets Sennheiser MM400