Sennheiser evolution wireless series EM 100 User Manual download pdf (Page 20)

Using the receiver

To establish a transmission link, proceed as follows:

1. Switch the receiver on (see next section).

2. Switch the transmitter on (see the instruction manual of the transmitter).

The transmission link is established and the receiver’s RF level display

“RF” reacts.

If you cannot establish a transmission link between transmitter and

receiver:

왘 Make sure that transmitter and receiver are set to the same frequency

bank and to the same channel.

왘 Read the chapter “Synchronizing transmitters with receivers” on

page 42 and, if necessary, the chapter “If a problem occurs ...” on

page 47.

Switching the receiver on/off

To switch the receiver on:

It is vital to observe the notes on frequency selection on page 42.

왘 Briefly press the STANDBY button .

The receiver switches on and the “Receiver Parameters” stan-

dard display appears.

533.875

ew100 G3

20.12

MHz

SET



PEAK

-10

-20

-30

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 58 59

No comments

Sennheiser evolution wireless series EM 100 User Manual Page 20