Configuring the conference system
50
There are two ways to integrate the access point into the network and to
use the web server. You can
• integrate the access point into a network with static IP addresses or
• integrate the access point into a network with DHCP.
To call up the IP address settings:
왘 In the main navigation, click “Setup” > “TCP/IP Settings”.
The “TCP/IP Settings” overview screen appears.
To set an unique network identification of the access point:
왘 In the “System Name” field, type a name for your conference system.
To use a dynamic IP address – “DHCP“:
왘 From the “IP Address Mode” drop-down list, select “DHCP”.
The access point automatically obtains its IP address from a server. In
order to be able to use this function, you need a DHCP server in your
network that automatically assigns IP addresses.
To use a static IP address – “Static“:
왘 From the “IP Address Mode” drop-down list, select “Static”.
왘 In the “IP Address” field, type the desired IP address.
왘 In the “Subnet Mask” field, type the desired subnet mask.
왘 Click “Save settings”.
The settings are saved.
왘 Switch the access point off and on again (see page 29).
You can now access the web server via the new IP address.
왘 In the address box of the browser, type the new IP address of the access
point.
Make sure that this IP address is not used in your network.
왘 Note down the IP address so that you can call up the web server
again.
Comments to this Manuals