Sennheiser A200 User Manual download pdf (Page 10)





Power supply

The A 200 is powered via the BA 151 rechargeable accuplug

which is both cost-saving and environmentally friendly. The

accuplug has an operating time of approx. 10–12 hours with the

volume set to a medium value. The operating time can be

extended by using a second accuplug (available as an accessory).

With a second accuplug, one accuplug can be stored in the L 200

charging unit to ensure that it is fully charged when needed. Since

the accuplug cannot be overcharged, it can remain in the charging

unit even when it has been fully charged.

Putting the receiver into operation

Insert the BA 151 accuplug into compartment  in the A 200.

NB.: The BA 151 accuplug must be charged for 24 hours

before first use! Take special note of the instructions on

accuplug operation on page 12 of this manual!

Switching on/off the a 200, adusting the volume

Use the rotary switch  located on the bottom of the A 200 to

switch on/off the device and adjust the volume.

The A 200 has a built-in limiter

If the user speaks or if loud and sudden noise occurs, the

amplification is reduced immediately. Unpleasant volume

peaks are thus avoided and the user perceives his own voice as

sounding completely natural. The volume limiter is factory-

adjusted to the optimum setting.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 38 39

No comments

Sennheiser A200 User Manual Page 10