Putting the headset system into operation
18
왘 Press either the LINK button on the headset or the PHONE
button 쐋 on the base station.
A wireless link is established between the headset and the base
station, the LINK
LED lights up blue and the HEADSET LED flashes
blue.
왘 Lift the handset (if a handset lifter is connected, it automatically lifts
the handset).
The system is correctly connected if you can hear a clear dial tone and
if the other party can hear you at a comfortable level. If the audio
signal/dial tone is disturbed, adjust the audio signal (see next section).
If the other party cannot hear you well, adjust the microphone
sensitivity (see below).
Adjusting the audio signal/dial tone
왘 Set the ABC switch to A (default setting), B or C so that you can hear a
clear dial tone in the headset.
Adjusting the microphone sensitivity
By default, the microphone volume control is set to between position 4
and position 5. This setting is suitable for most telephones and your voice
gets reproduced at a good volume. To change the volume, adjust the
microphone volume control accordingly.
왘 Make a call to someone who will help you find the correct sensitivity
setting for your microphone (see page
25).
왘 Turn the microphone volume control so that the other party can hear
at a comfortable level.
4
3
The microphone volume control only adjusts the microphone
sensitivity in Phone mode.
Comments to this Manuals