Sennheiser HME 26-600 S Specifications download pdf (Page 43)

SENNHEISER PRODUCTS 2010

Set 840 S – Specially designed for

wearers of hearing aids, the Set 840 S trans-

mits stereo sound via a radio frequency con-

nection from the television or hi-fi system

up to 100 m – even through walls. The signal

is received clearly and precisely by a hearing

aid with activated telecoil via the induction

loop. Alternatively, normal headphones or

induction couplers can be connected to the

receiver. After use the receiver can be placed

in the charging cradle facing either way.

Carrier frequencies:

925.95 MHz/ 926.8 MHz/ 927.5 MHz

Frequency response: 50–16,000 Hz

Range: up to 300 ft. or 98 ft.

Set 830 S The Set 830 S is essentially the

same as the Set 840 S, but does not transmit

a radio frequency signal, it transmits an

infrared signal up to 12 m within a room.

The signal is transmitted from the receiver

to the hearing aid with activated telecoil

via the induction loop supplied with the set.

You can choose from three hearing settings

on the transmitter and adjust compression

and treble emphasis to optimise the speech

intelligibility and sound quality. Volume and

balance control are conveniently located on

the receiver.

Carrier frequencies: 2.3 MHz/ 2.8 MHz

Frequency response: 50–16,000 Hz

Range: up to 40 ft.

NEW

Audioport A 200 The A 200 audio-

port is a good alternative for people who

would like amplified sound occasionally,

but do not want to wear a hearing aid. Two

integrated microphones transmit voices and

sounds in detail and amplified to the ears.

Furthermore, the A 200 is very easy to use.

The on/off switch and the volume control

are positioned directly on the receiver. And

when it is not needed, it is simply put in the

cradle to recharge.

Frequency response: 200–12,000 Hz

Microphones: Pre-polarized condenser

mics, stereo

EZT 3011 The EZT 3011 is an induction

loop for use with the RI 830 S and RR 840 S

receivers. It transmits the audio signal from

the receiver to hearing aids with an induction

coil. You can attach the receiver directly to

the induction loop and wear it. The EZT 3011

is equipped with a 3.5 mm stereo jack plug.

EZT 3012 The EZT 3012 is an induction

loop for use with Sennheiser’s wireless

receivers. It transmits the audio signal from

the receiver to hearing aids with an induction

coil. The induction loop is equipped with a

40 cm long connection cable with a 3.5 mm

stereo jack plug.

ASSISTIVE LISTENING DEVICES AUDIOLOGY

NEW

085084

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 76 77

Comments to this Manuals

No comments