Sennheiser MM 450-X TRAVEL Instruction Manual download pdf (Page 14)

Putting the MM 450 into operation

Pairing the MM 450 with an audio source

When switching the headset on for the first time, it will automatically go

into pairing mode. The headset is waiting to be paired with a Bluetooth

enabled device (see page 12).

왘 Press the Master button 햶 and keep it pressed until the LED 햲

alternately flashes blue and red.

왘 On your audio source, activate the Bluetooth function “Add a new

device”.

왘 Proceed as described in the instruction manual of the audio source.

If a suitable audio source is found, the devices will exchange device

identification information. The LED 햲 flashes 3 times blue and you hear

an ascending beep. The devices have identified each other and the headset

is paired with the audio source.

If no device is found within approx. 5 minutes, the LED 햲 flashes

3 times red and you hear a descending beep. The headset will then try for

3 minutes to connect to one of the up to 8 previously paired audio sources.

If this fails, the headset automatically switches off after 60 minutes.

왘 In this case, repeat the necessary steps to pair the headset with the

audio source again.

Switching the “Bluetooth connection” flashing on/off

왘 Switch the headset off (see “Switching the MM 450 off” on page 11).

To switch the flashing on during a Bluetooth connection:

왘 Press the Master button 햶 and keep it pressed until the LED 햲

alternately flashes blue and red.

왘 Briefly press the Volume  button 햷.

To switch the flashing off during a Bluetooth connection:

왘 Briefly press the Volume  button 햴.

Disconnecting the Bluetooth connection

왘 Make sure that your headset is switched off (see

“Switching the MM 450 off” on page 11).

PIN code

When the audio source prompts for a password or PIN code,

enter the default PIN code “0000”.

The Bluetooth button 쐄 is backlit, indicating the current

setting. The backlighting goes off after a short time to

conserve energy.

왘 Press any button on the headset to display the current

setting of the Bluetooth function.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

No comments

Sennheiser MM 450-X TRAVEL Instruction Manual Page 14