Sennheiser Rack-mount Receiver EM 300 G3 User Manual download pdf (Page 21)

Using the receiver

To establish a transmission link, proceed as follows:

1. Switch the receiver on (see next section).

2. Switch the transmitter on (see the instruction manual of the trans-

mitter).

The transmission link is established and the display backlighting of the

receiver changes from red to orange.

If you cannot establish a transmission link between transmitter and

receiver:

왘 Make sure that transmitter and receiver are set to the same frequency

bank and to the same channel.

왘 Read the chapter “Synchronizing transmitters with receivers” on

page 44 and, if necessary, the chapter “If a problem occurs ...” on

page 50.

Switching the receiver on/off

To switch the receiver on:

It is vital to observe the notes on frequency selection on page 44.

왘 Briefly press the STANDBY button .

The receiver switches on and the “Receiver Parameters” stan-

dard display appears.



531.375

SKM300

ew300 G3

B.Ch: 20.24

+ 12dB

MHz

PEAK

-10

040

-20

-40

-30

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 61 62

No comments

Sennheiser Rack-mount Receiver EM 300 G3 User Manual Page 21