Sennheiser EMP 2015 Instruction Manual download pdf (Page 15)







Connecting external audio devices

You can connect two mono or two stereo audio devices to the amplifier.

씰 Connect the RCA plugs of the sound recording devices to the RCA sockets

(LINE IN)  at the rear of the EMP 2015. For correct connection of the

different audio devices, please refer to the diagrams at the left.

Note:

Stereo (left-right) signals are mixed in the amplifier and are then available

as a mono signal.

씰 If possible, set stereo audio devices to “mono” operation. If sound

problems occur, use the left channel of TVs and VCRs.

Adjusting the volume of an external audio device

You can adjust the volume of the connected audio device (e.g. VCR) separately

from the volume of the speaker’s microphone. If, however, you have connected

two audio devices to the line input, the volume control adjusts the volume of

both devices.

씰 Use the volume control (LINE IN)  to adjust the volume of the

connected device.

Note

If the audio signal sounds distorted, reduce the sensitivity of the system

with control . If control  is turned counterclockwise as far as possible,

the audio signal may not be audible.

2 mono audio devices

1 stereo audio device

2 stereo audio devices

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

No comments

Sennheiser EMP 2015 Instruction Manual Page 15