Sennheiser EK 100 G3 Instruction Manual download pdf (Page 19)

Using the devices

To establish a transmission link, proceed as follows:

1. Switch the receiver on.

2. Switch a transmitter on.

The transmission link is established and the receiver’s RF level display “RF” reacts.

If you cannot establish a transmission link between transmitter and receiver:

 Make sure that transmitter and receiver are set to the same frequency bank and to the

same channel.

 If necessary, read the chapter “If a problem occurs ...” on page 28.

Switching the devices on/off

EM 100 receiver

To switch the receiver on:

To switch the receiver to standby mode:

 If necessary, deactivate the lock mode (see page 21).

It is vital to observe the following notes:

 Make sure that the desired frequencies are listed in the enclosed frequency

information sheet.

 Make sure that the desired frequencies are approved and legal in your country

and, if necessary, apply for an operating license.

 

쐊 쐊

00 G3

MHz

SET

쐂

 Briefly press the STANDBY button 쐂.

The receiver switches on and the “Receiver Parameters” standard display appears.

 Keep the STANDBY button 쐂

pressed until “OFF” appears on the display panel.

When in the operating menu, pressing the STANDBY button 쐂 will cancel your entry

(ESC function) and return you to the current standard display.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

No comments

Sennheiser EK 100 G3 Instruction Manual Page 19