Sennheiser RS 2400 Instruction Manual download pdf (Page 7)

Automatic on/off switching

The transmitter features a convenient automatic on/off function. When an audio signal rea-

ches the transmitter, it is switched on and the LED  at the front of the transmitter lights up

green. The LED  also indicates that an accupack is being recharged. When a stethoset recei-

ver or an accupack is inserted into a charging compartment, the LED lights up red.

Green LED = Transmitter ON

Yellow LED = Transmitter ON, Accupack recharging

Red LED = Accupack recharging

LED not lit = Transmitter OFF

If there is no audio signal for about 3 minutes, the transmitter automatically switches off. The

transmitter is now in stand-by mode, its power consumption is very low so that it can remain

connected to the mains.

Important

왘 The transmitter’s charging function is independent of the automatic on/off function. Accu-

packs can always be recharged when the transmitter is connected to the mains.

왘 When you are not going to use the transmitter for some time (e.g. when you are on holiday),

you should unplug the mains unit and take the stethoset receiver and the accupack out of

their respective charging compartments.

Adjustments on your TV set

왘 Please refer to the instruction manual of your TV set to find out whether the volume control

also adjusts the headphone output or whether this output has a separate volume control.

You will also find instructions on how to switch off the main loudspeakers.

RS 2400_512759_0106_Sp6.book Seite 18 Mittwoch, 15. Februar 2006 8:34 08

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Sennheiser RS 2400 Instruction Manual Page 7