Sennheiser W300 User Manual download pdf (Page 15)

SK 300 G2 bodypack transmitter

Inserting and replacing the batteries

For powering the SK 300 G2 bodypack transmitter, use two 1.5 V AA size

batteries.

 Press the two unlocking buttons  and open the battery compartment

cover .

 Insert the two batteries as shown in the diagram on the left. Please

observe correct polarity when inserting the batteries.

 Close the battery compartment. The battery compartment cover  locks

into place with an audible click.

Inserting and charging the accupack

The bodypack transmitter can also be powered via the rechargeable

Sennheiser BA 2015 accupack. Insert the accupack into the battery

compartment as described above.

The transmitter has two charging contacts  and a sensing contact on its

short sides. The accupack can be recharged while remaining in the

transmitter. Insert the transmitter into the L 2015 charger (see operating

manual of the L 2015 charger).

Note:

For accupack operation of the transmitter, only use the BA 2015 accupack

In order to ensure optimum operational reliability. For charging the

accupack, only use the L 2015 charger. Both the accupack and the charger

are available as accessories.

The accupack is fitted with an integrated sensor which is – via a third

contact – monitored by the electronics of the transmitter and the charger.

The sensor is necessary for the following control purposes:

y The taking into account of the different voltage characteristics of

primary cells (batteries) and accupacks. The battery status indications

on the displays, the transmission of transmitter battery status

information to the rack-mount receivers and the switch-off thresholds

at the end of the operating time are corrected correspondingly. Due to

the missing sensor, individual rechargeable battery cells will not be

identified as accupacks.

y The monitoring of the accupack temperature during charging in the

L 2015 charger.

y The prevention of improper charging of inserted primary cells (batte-

ries). Due to the missing sensor, individual rechargeable battery cells

will also not be charged in the L 2015 charger.

Connecting the microphone/line cable

The microphone/line input is designed for the connection of both condenser

microphones and instruments (e.g. guitars). DC powering of the condenser

microphones is via the microphone/line input.

 Connect the 3.5 mm jack plug  from the microphone/line cable to the

3.5 mm jack socket (MIC/LINE) '.

 Lock the 3.5 mm jack plug by screwing down the coupling ring .

 Via the operating menu, adjust the sensitivity of the microphone/line

input (see “Adjusting the sensitivity (transmitters only)“ on page 30).











1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 44 45

Comments to this Manuals

No comments

Sennheiser W300 User Manual Page 15

Comments to this Manuals