Adjustment tips
19
If no transmitter is being received or if the signal is below the squelch threshold level,
“MUTE” appears.
왘 With the transmitter, walk up and down the transmission area.
The receiver records the following parameters and displays them on the “Soundcheck”
standard display:
Synchronizing a transmitter with the receiver
When synchronizing a transmitter with a receiver, please observe the following:
Synchronizing a transmitter with the receiver – individual operation
Upon delivery, transmitter and receiver are synchronized with each other. However, if you
cannot establish a transmission link between transmitter and receiver, you have to synchro-
nize the channels of the devices:
왘 With the receiver, perform a frequency preset scan to scan the frequency banks for
unused channels (“Scan New List”, see page 17).
“
Soundcheck”
standard display
“
Receiver Parameters”
standard display
543.200
ew300 G3
B.CH: 20.24
MUTE
EQ:
+ 12dB
MHz
PEAK
-10
0
40
30
20
10
-20
-30
-40
AF
RF
PEAK
-10
0
-20
-30
-40
AF
40
30
20
10
RF
Soundcheck
20.24 ew300 G3
543.200
MHz
SKM300
P
P
PEAK
-10
0
-20
-30
-40
AF
40
30
20
10
RF
P
AF MaxRF Max
RF Min
Soundcheck
20.24 ew300 G3
543.200
MHz
Display Meaning What to do ...
RF Min Min. RF signal level:
• must be well above the
squelch threshold level for
one of the two antennas
왘 Check if the antennas and the antenna
cables are correctly connected.
왘 Improve the position of the antennas.
왘 If necessary, use antenna boosters.
RF Max Max. RF signal level:
• both antennas should reach
40 dBμV
AF Max Max. audio level 왘 On your transmitter, adjust the audio
level as high as possible without the level
display for audio level showing full
deflection (AF Max is at a level with the
PEAK display).
For more information, refer to the
instruction manual of the transmitter.
왘 Only use a transmitter and a receiver from the same frequency range (see the
type plate on the transmitter and the receiver).
왘 Make sure that the desired frequencies are listed in the enclosed frequency
information sheet.
왘 Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.
Comments to this Manuals