Sennheiser EM 300 G3 - 01-09 Instruction Manual download pdf (Page 22)

Adjustment tips

왘 Select a channel on your receiver (“Current List”, see page 17).

The receiving frequency of the channel must be approved and legal in your country

(see above).

왘 Synchronize a transmitter with the receiver via the infra-red interface (see page 13).

This establishes a transmission link between the transmitter and the receiver.

Alternatively, you can set the channel on the transmitter manually:

왘 Make sure that you set the transmitter to the same frequency bank and the same

channel as the receiver.

For information on the setting options of the transmitter, refer to the instruction manual

of the transmitter.

Synchronizing transmitters with receivers – multi-channel operation

Network operation In multi-channel operation, the receivers are remote controlled via a PC running the “Wireless

Systems Manager” (WSM) software.

왘 Connect the receivers in a network (see page 12).

왘 Launch the “Wireless Systems Manager” (WSM) software.

왘 To scan for unused receiving frequencies and to configure the receivers, proceed as

described in the instruction manual of the “Wireless Systems Manager” (WSM) software.

왘 Set the linked transmitter to the selected frequency bank and to the selected channel

either by synchronizing the transmitter with the receiver (see page 13) or by setting

the frequency bank and the channel manually (see the instruction manual of the trans-

mitter).

Your multi-channel system is now set up.

Operation

without network

왘 Switch off all transmitters of your system that are to be automatically configured.

Channels used by switched-on transmitters are displayed as “used”.

왘 With one of the receivers, perform a frequency preset scan to scan the frequency banks

for unused channels (“Scan New List”, see page 17).

왘 Select a channel on this receiver (“Current List”, see page 17).

The receiving frequency of the channel must be approved and legal in your country

(see above).

왘 Synchronize a transmitter with the receiver via the infra-red interface (see page 13).

This establishes a transmission link between the transmitter and the receiver.

왘 Repeat for the remaining transmitter and receiver pairs as described above.

WSM

Advantages of controlling the receivers via the “Wireless Systems Manager” (WSM)

software:

• Detailed overview of all receiving channels

• Remote control of all receivers in the network

• Combination of receivers of different frequency ranges (see page 4)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

No comments

Sennheiser EM 300 G3 - 01-09 Instruction Manual Page 22