Sennheiser EK 300 IEM Specifications download pdf (Page 36)

If a problem occurs ...

Error checklist

If a problem occurs that is not listed in the above table or if the problem cannot be solved with the proposed

solutions, please contact your local Sennheiser agent for assistance.

Problem Possible cause Possible solution

No operation indication Batteries are flat or

accupack is flat (receiver only)

Replace the batteries or

recharge the accupack

No mains connection (transmitter

only)

Check the connections of the mains

unit

No RF signal Transmitter and receiver are not on

the same channel

Set transmitter and receiver to the

same channel

Transmission range is exceeded Check the squelch threshold setting

(see “Adjusting the squelch

threshold (receiver only)” on

page 29)

or reduce the distance between

transmitting antenna and receiver

RF signal available,

no audio signal,

“MUTE” display appears on

the display panel

Transmitter is set to mono operation

and the pilot tone evaluation of the

receiver is activated

Deactivate the pilot tone evaluation

on the receiver

Receiver’s squelch threshold is

adjusted too high

See “Adjusting the squelch threshold

(receiver only)” on page 29)

Audio signal has a high level

of background noise

Transmitter sensitivity is adjusted

too low

See “Adjusting the sensitivity

(transmitter only)” on page 30

Audio signal is distorted Transmitter sensitivity is adjusted

too high

See “Adjusting the sensitivity

(transmitter only)” on page 30

No access to a certain channel During scanning, an RF signal has

been detected on this channel and

the channel has been locked

See “Scanning the channel banks for

free channels (receiver only)” on

page 28

ew300_350_IEM_INT.book Seite 34 Freitag, 7. März 2008 8:55 08

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 45 46

Comments to this Manuals

No comments

Sennheiser EK 300 IEM Specifications Page 36

Comments to this Manuals

Related products and manuals for AV receivers Sennheiser EK 300 IEM