Sennheiser Surrounder User Manual download pdf (Page 20)

NT 12

Front

Rear

Soundcard

4 Putting the Surrounder into operation

Before you put the Surrounder into operation, please first check

that the Surrounder’s volume control is set to minimum.

Connecting the Surrounder to the mains

• Connect the DC socket of the connection cable to the cable of the power supply unit.

• Plug the power supply unit into a wall socket. The power supply unit may remain

connected to the mains as its current consumption is very low (less than 2 W) if the

volume is set to minimum. However, to protect the environment you should save energy

and unplug the power supply unit when you are not going to use the Surrounder for

some time (e.g. when you are away on holiday).

The illustrations below also show how to connect the Surrounder to the mains.

5 Connection to the sound source

The Surrounder can be connected to almost any stereo and multi-channel sound source.

Please note that the best acoustic result is achieved if the Surrounder is connected to a multi-

channel surround system.

4-CHANNEL SOUNDCARD (PC)

A 4-channel soundcard (PC) supplies the corresponding front and rear, left and right

speakers with four different audio signals.

Only connect the Surrounder to a 4-channel PC soundcard, never connect it to the

normal speaker outputs of a computer (this may cause severe damage to your

Surrounder).

• Connect the jack plug labelled “F” to the output labelled “Front” on the PC soundcard.

• Connect the jack plug labelled “R” to the output labelled “Rear” on the PC soundcard.

Connection to a 4-channel soundcard

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 73 74

No comments

Sennheiser Surrounder User Manual Page 20