Sennheiser EM 300 Instruction Manual download pdf (Page 26)

SenSit

Selecting the frequency, channel number

! With the !/" buttons you can directly switch between the factory-

preset frequencies (channel presets). The display starts flashing. Your

ele

tion be

ome

effe

tive immediately.

! Press the SET button to acknowledge your selection. The display stops

flashing. (If the SET button is not pressed, the receiver will store the

new frequency automatically on switch-off.)

Note:

Yo u c a n c h o o s e t h e c o n t e n t o f t h e s t a n d a rd d i s p l a y i . e . w h e t h e r t h e

frequency or the channel number is displayed (# “Selecting the content

of the standard display”). The receiver is factory-preset to show the

frequency setting as standard.

Adjusting the sensitvity (transmitters only)

Close talking distances, speakers with loud voices or loud music sequences

may cause overmodulation in the transmission link, resulting in distortion.

In this case, the “PEAK” warning of the EM 100’s AF level display (as well as

the SK 100 transmitter’s yellow audio peak indication LED) will light up. If,

on the other hand, the sensitivity is adjusted too low, the transmission link

will be undermodulated, which would result in a signal with high background

noise.

The sensitivity has to be adjusted such that the “PEAK” warning of the

receiver’s AF level display only lights up during the loudest passages.

The following figures are a guide to the best settings:

Loud music/vocals: -30 / -20 dB

Presentations: -20 / -10 dB

Interviews: -10 / 0 dB

! Select the “SEnSit” menu by pressing the SET button until “SEnSit”

appears on the display; after a short pause the current sensitivity setting

is displayed.

! With the !/" buttons you can now select a different setting. The

sensitivity can be adjusted in 10-dB steps from 0 to -30 dB. The new

setting starts flashing on the display and becomes effective immediately.

! Press the SET button to return to the top menu level. The display

then switches back to the standard display.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 42 43

No comments

Sennheiser EM 300 Instruction Manual Page 26