Sennheiser 504302 User Manual download pdf (Page 24)

Using the headset system

Switching the headset on/off

Switching the headset on

왘 Press and hold the LINK button  for 5 seconds.

The HEADSET LED  flashes blue 3 times and the wireless link to the

base station is established (where required). An ascending confirma-

tion beep is heard in the headset.

Switching the headset off

왘 Press and hold the LINK button  for 5 seconds.

The HEADSET LED  flashes red 3 times.

Establishing a wireless link between headset and

base

station

To establish a wireless link between headset and base station:

왘 Press the LINK button  on the headset.

The link is established. The LINK LED  lights up blue and the

HEADSET LED  flashes blue.

To disconnect a wireless link between headset and base station:

왘 Press the LINK button  on the headset.

The link is disconnected. The LINK LED  and the HEADSET LED  go

off.

If you place the headset into the base station, the headset automat-

ically switches to standby mode. In standby mode, the power

consumption is very low and the radiated power is reduced to a

minimum. The HEADSET

LED  lights up blue and the rechargeable

battery is being charged.







You can also establish or disconnect the wireless link by pressing

the PC button

 or the PHONE button 쐋 on the base station

(depending on the selected mode (PC or Phone), see page 28).

If your telephone has a built-in electronic hook switch supporting

the MSH standard (see page

13), you can only disconnect the wire-

less link between headset and base station by placing the headset

into the base station. The control signals (“accept a call”, “end a

call”) of the headset are still transmitted to the electronic hook

switch without.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

No comments

Sennheiser 504302 User Manual Page 24