Sennheiser 504302 User Manual download pdf (Page 32)

Using the headset system

Pairing is not successful If pairing is not successful within 60 seconds, the DW Office headset

switches to standby mode.

왘 For information on how to pair the headset to the non-DW Office base

station, refer to the instruction manual of the base station.

Charging an additional headset

If you wish to charge an additional headset (headset b) in the base station

while you are using your headset (headset a):

왘 Make sure that a wireless link is established between headset a and

base station (the LINK

LED  on the base station lights up blue).

왘 Place headset b into the base station.

Headset a can continue to connect to and disconnect from the base

station and its use is not restricted while headset b is being charged.

If you leave the DECT range

If you leave the DECT range during a call, the audio quality deteriorates.

When the link breaks down completely, you hear a descending sequence

of beeps in the headset and the LINK

LED  on the base station lights up

red.

To resume the call:

왘 Re-enter the DECT range of the headset system within 60 seconds.

As soon as the headset re-establishes the wireless link to the base

station, you hear a ring tone in the headset.

왘 Press the LINK button  on the headset to resume the call.

If a handset lifter/electronic hook switch is used or if your soft-

phone supports call control, the call will automatically be ended

seconds after leaving the DECT range.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

No comments

Sennheiser 504302 User Manual Page 32