Sennheiser EW100 G2 User Manual download pdf (Page 34)

IMPORTANT! Notes:

If the squelch threshold is adjusted too high, the transmission range will

be reduced. Therefore, always adjust the squelch threshold to the lowest

possible setting. The squelch threshold is factory-preset to “LO”.

When in the setting mode of the “SQELCH” menu, pressing the  button

(DOWN) for more than three seconds will switch the squelch off. “SQ.OFF”

appears on the display. If no RF signal is being received, hissing noise will

occur. This setting is for test purposes only.

Selecting the standard display

DISPLY

Via the “DISPLY” menu, you can select the standard display:

Entering a name

NAME

Via the “NAME” menu, you can enter a freely selectable name for each trans-

mitter and receiver. You can, for example, enter the name of the performer

for whom the adjustments have been made.

The name can be displayed on the standard display and can consist of up to

six characters such as:

y letters (without pronounciation marks),

y numbers from 0 to 9,

y special characters e.g. () - . _ and spaces.

To enter a name, proceed as follows:

 Press the SET button to get into the setting mode of the “NAME” menu.

The first segment starts flashing on the display.

 With the / buttons you can now select a character. By briefly pressing

a button, the display jumps either forwards or backwards to the next cha-

racter. If you hold down a button, the display starts cycling continuously.

 Press the SET button to change to the next segment and select the next

character.

 Have you entered the name completely? Press the SET button to store

your setting and to return to the previous menu level.

selectable

Standard display

Contents of standard display

EM 100 G2 EK 100 G2

SK 100 G2, SKM 100 G2,

SKP 100 G2

„FREQ“

„NAME“

„CHAN“ ⎯

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 46 47

No comments

Sennheiser EW100 G2 User Manual Page 34