SKP 300 G3 | 23
Synchronizing the plug-on transmitter with a receiver
Synchronizing the plug-on
transmitter with a receiver
When synchronizing the plug-on transmitter with a
receiver, please observe the following:
Synchronizing the plug-on transmitter
with the receiver – individual operation
Upon delivery, the plug-on transmitter and the receiver
are synchronized with each other. If, however, you
cannot establish a transmission link between plug-on
transmitter and receiver, you have to synchronize the
channels of the devices.
For information on automatic synchronization of the
plug-on transmitter with the receiver (individual opera-
tion), refer to the instruction manual of the receiver.
This information is marked with the icon.
Alternatively, you can set the channel on the plug-on
transmitter manually:
왘 Make sure that you set the plug-on transmitter to
the same frequency bank and the same channel as
the receiver (see page 18).
If you still cannot establish a transmission link, refer to
the chapter “If a problem occurs ...” on page 27.
왘 Only use a plug-on transmitter and a receiver
from the same frequency range (see the type
plates on the transmitter and the receiver).
왘 Make sure that the desired frequencies are
listed in the enclosed frequency information
sheet.
왘 Make sure that the desired frequencies are
approved and legal in your country and, if
necessary, apply for an operating license.
왘 Make sure that transmitter and receiver have at
least software version 1.7 (see page 22).
The most current software version is available
from your Sennheiser partner or can be down-
loaded from the SKP 300 G3 product page at
www.sennheiser.com.
Comments to this Manuals