Sennheiser EVOLUTIONWIRELESS SKP 100 User Manual download pdf (Page 19)

Cleaning the plug-on transmitter

왘 Use a slightly damp cloth to clean the plug-on transmitter from time to

time. Do not use any solvents or cleansing agents.

Recommendations and tips

CAUTION! Liquids can damage the electronics of the plug-on

transmitter!

Liquids entering the housing of the device can cause a

short-circuit and damage the electronics.

왘 Keep all liquids away from the plug-on transmitter.

... for the plug-on transmitter

• For best results, make sure that the transmitter sensitivity is correctly

adjusted.

... for optimum reception

• Transmission range depends to a large extent on location and can vary

from about 10 m to about 150 m. There should be a “free line of sight”

between plug-on transmitter and receiving antennas.

• To avoid overloading the receiver, observe a minimum distance of 5 m

between plug-on transmitter and receiving antennas.

• The plug-on transmitter uses the microphone body as an antenna –

therefore microphones with a metal casing should be used for best

signal transmission.

... for multi-channel operation

• When operating a multi-channel system, you should only use the

channels within one frequency bank. Each of the frequency banks “1”

to “20” accommodates factory-preset frequencies which are inter-

modulation-free.

• When using several transmitters simultaneously, interference can be

avoided by maintaining a minimum distance of 20 cm between two

transmitters.

SKP100_529675_0409_Sp9.book Seite 18 Donnerstag, 9. April 2009 1:48 13

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

Sennheiser EVOLUTIONWIRELESS SKP 100 User Manual Page 19