Sennheiser SKM 1032 User Manual download pdf (Page 18)

How to adjust the transmitter frequency

Adjust the desired transmitter frequency with the switch . Each number on the

switch corresponds to a transmitter frequency. You will find the exact frequency

on the type plate in the battery compartment.

왘 Take care that the transmitter frequency and the received frequency selected

at the receiver do correspond.

왘 A small screw driver (breadth approx. 2 mm) or the end of the wire antenna

which is shaped like a small blade is suitable tools for the selection.

How to switch on / how to select sensitivity

The ON/OFF-switch  and the selector switch  are positioned in a cavity on the

bottom of the housing.

왘 The ON/OFF-switch which is used more frequently is positioned slightly

above the selector switch.

After having switched on the transmitter you must wait approx. 2 seconds as the

transmitter requires this time for adjusting to the chosen frequency. (PLL-rest.).

The AF signal is attenuated if the selector switch for the sensitivity  is switched

to „LOW“. Close-miking can thereby not result in overmodulation.

왘 Attenuation for SKM 1030: approx. 14 dB

왘 Attenuation for SKM 1032: approx. 20 dB











1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

No comments

Sennheiser SKM 1032 User Manual Page 18