Sennheiser HSL-10 Instruction Manual download pdf (Page 7)

 Always make sure not to cover the hole of the microphone  with the double-sided adhesive tape.



Connect the jack plug of the microphone to the microphone socket .

Connecting the handset lifter to the base station

 Connect the ACCESSORIES socket on the base station with the handset lifter’s modular

socket  using the cable provided. The LED  lights up green five times, if the base station

is connected to power.

 Test the HSL 10 by pressing the hook button on the base station. The lever should move.

Connecting the handset lifter to the telephone

Note!

You can use the adhesive mounting tape only once. Therefore, we recommend not to remove

the backing from the tape before you have determined the correct attachment position as

follows:

 With the handset put on, hold the HSL 10 handset lifter between the telephone and the

handset, as close to the handset loudspeaker as possible.

 In order to check whether the HSL 10 is in the correct position or not, press the hook button

on your mobile device or the base station, respectively. The position is correct, if the

lifting pad  raises only the loudspeaker side of the handset and you can hear a dial tone.

 Remove the backing from the adhesive tape and affix the HSL 10 with the adhesive tape.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Sennheiser HSL-10 Instruction Manual Page 7