Sennheiser evolution wireless serie ew500 User Manual download pdf (Page 72)

Battery status indication

The red LED  and the lower 8-segment bargraph on the display provide

information on the (remaining) battery capacity.

Bargraph:

The bargraph indicates the (remaining) battery capacity in 3 steps:

8 segments: the full battery capacity is available,

4 segments: the battery capacity is sufficient,

1 segment: the battery is going flat,

immediately replace the battery.

Note:

When switching on the transmitter with a partially used battery, it is

possible that all eight segments may show for a short period of time –

if this happens, re-check battery status after a few moments.

LED lit up:

The transmitter is switched on and the battery capacity is sufficient.

LED flashing:

The battery is going flat! You should immediately replace the battery!

Changing the microphone module

씰 First remove the battery and leave the radiomicrophone open.

씰 Unscrew the sound inlet basket.

씰 Loosen the screw and put it aside.

씰 Remove the microphone module, as shown. Do not touch the contacts!

씰 Insert the new module, secure the capsule by tightening the screw,

put on the suitable sound inlet basket and coloured identification ring

and screw it tight.

씰 Insert the battery, close the radiomicrophone and put it into operation.

Note:

Microphone module, sound inlet basket and foam insert form an

acoustic unit and must therefore always be exchanged all together.

Each microphone module comes with a colour-coded identification

ring to distinguish different microphone modules from each other

(green = MD 835, blue = MD 845, red = ME 865).

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 203 204

No comments

Sennheiser evolution wireless serie ew500 User Manual Page 72