15
왘
>
<
Low-Batt
Battery or rechargeable
battery operation ?
For regular operation you should use non-
polluting rechargeable batteries (BA 5000-1)
instead of batteries.
LC display of the power packs
B 5000-1 battery pack:
• 3-step LC display for (remaining) battery
capacity
• Reliable Low Batt indication
• Protection against total discharge
• Provision of battery status information for
the receiver
• Operating time (with alkaline manganese
cells): B 5000-1: > 4.5 h on SKM 5000
BA 5000-1 accupack:
• 6-step LC display for (remaining) recharge-
able battery capacity
• NiMH rechargeable batteries with 1.5 Ah
capacity
• Charging time max. 2.5 h with L 50 charger
(depending on the residual charge of the
rechargeable battery)
• Indication of partial discharge via LC display
• Protection against total discharge
... Indication at the EM 1046 (Example)
The display of an EM 1046-RX-module
(channel module),too, indicates the residual
operating time in %. The residual operating
time of approx. 30 minutes (see above) is
indicated by the blinking warning signal
„LowBatt“.
Note
왘 You will find a corresponding description
in the instructions for the EM 1046 / EM
3031 / EM 3032 / EM 3532 / EK 3041.
SKM 5000, BDA 06/02 04.06.2002, 11:18 Uhr15
Comments to this Manuals