Sennheiser EM 3532-U Service Manual download pdf (Page 30)



24 Sennheiser transmitters report their battery status

Sennheiser supplies hand-held and pocket transmitters which provide information on the available

transmitter battery status to the receiver. This information can be evaluated with the EM 3532

receiver.

 The remaining battery capacity is first indicated via the six-step bargraph on the display

panel .

 When the battery capacity is so low that only a transmission time of about 20 to 30 minutes

remains, the “LOW BATT” display flashes on the display panel .

You should now immediately replace the transmitter battery. The AMF (

Advanced Muting

Function) in the EM 3532 receiver helps you, as far as possible, to maintain the transmission

without noise.

Notes

씰 The “LOW BATT” display is reset by the mute function. Whenever the squelch is activated

in the receiver, the “

LOW BATT” display goes off and the evaluation of the battery status

signal from the transmitter starts over again.

씰 Under favourable reception conditions, the evaluation of the battery information from the

transmitter lasts about 10 – 20 seconds. However, it can be significantly longer if reception

is subject to interference from time to time. This time is then also needed by the display in

display panel

 in order to update the information shown.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35

No comments

Sennheiser EM 3532-U Service Manual Page 30