Sennheiser EK 300 IEM User Manual download pdf (Page 10)

Using the diversity receiver

To establish a transmission link, proceed as follows:

1. Switch the diversity receiver on (see next section)

2. Switch a transmitter on

(

see the instruction manual of the trans-

mitter

The transmission link is established and the receiver’s RF level display

“RF” 햲 reacts.

If you cannot establish a transmission link between transmitter and

receiver, read the chapter “Synchronizing an SR 300 IEM G3 transmitter

with the diversity receiver” on page 20.

Switching the diversity receiver on/off and adjusting

the volume

To switch the diversity receiver on:

왘 Turn the volume control 쐃 clockwise until it clicks.

The red ON LED 쐏 lights up. The “Frequency/Name” standard display

appears on the display panel.

To switch the diversity receiver off:

왘 Turn the volume control 쐃 counterclockwise until it clicks.

The red ON LED 쐏 goes off and the diversity receiver switches off.

To adjust the volume:

왘 Turn the volume control 쐃.

It is vital to observe the notes on frequency selection on page 20.

CAUTION! Hearing damage due to high volumes!

Listening at high volume levels for long periods can lead

to permanent hearing defects.

왘 Set the volume to a low level before putting the

earphones on.

왘 Do not continuously expose yourself to high volumes.





1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

No comments

Sennheiser EK 300 IEM User Manual Page 10