Sennheiser NET 1 Specifications download pdf (Page 22)

Transferring frequencies to the transmitters

The infra-red interface of the SK 5212 bodypack transmitter is located under

the display in the black frame. The infra-red interfaces of the SKM 5200 hand-

held transmitters and the SKP 3000 plug-on transmitters are is located under

the display’s faceplate.

Note:

Strong extraneous light may interfere with the transfer of the trans-

mission frequencies via the infra-red interface. Therefore, position the

NET 1 so that any possible interference caused by extraneous light is

avoided.

왘 Switch on the transmitter as described in the instructions for use of the

transmitter.

왘 Place the transmitter in front of the infra-red interface . The distance

between the infra-red interface of the NET 1 and the infra-red interface of

the transmitter should be approx. 10 cm.

왘 On the NET 1, press the channel button  of the receiver whose frequency

you want to transfer.

The green “CHANNEL” LED  of the selected receiver flashes rapidly,

indicating that data is being transferred to the transmitter. At the same

time, the yellow “DATA LINK” LED  flashes slowly and the infra-red

interface  is permanently backlit in blue.

When the frequency transfer is completed, the green “CHANNEL” LED 

and the “DATA LINK” LED  light up permanently.

If the frequency transfer was unsuccessful, the “ERROR” LED  flashes

rapidly for approx. 3 seconds and the green “CHANNEL” LED  flashes

permanently. In this case, reposition the transmitter until the frequency

transfer is successfully completed.

SK 5212

SKP 3000

SKM 5200

10 cm







1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

No comments

Sennheiser NET 1 Specifications Page 22