Sennheiser HD400 User Manual download pdf (Page 56)

FX Models

6•14

Common FX3 Parameters

When you enter Edit Mode for any FX3 model, you’ll see the following common parameters

for most (as well as “Model Select” and “Routing,” as described on page 6•3):

Tap Control

Set to Control to have all FX3 models’ Delay time follow the current Tap Tempo, which

you can deﬁne by using the TA P button. Or, set to Don’t Ctrl to manually set a Delay

Time - See the following section. The TapCtl setting is a “global” parameter and not

stored with your Preset. Also see “Tap Tempo” on page 2•4.

Time / Tempo

Sets the Delay/Echo repeat time. The following behaviors apply:

• If the TapCtl parameter (see above) is set to Don’tCtl, this parameter appears as

Time and the PRESETS knob adjusts it in millisecond (ms) increments. The FX3

models will use this ms value for their Time and will ignore the current Tap Tempo.

• Push and hold the PRESETS knob while turning to adjust the value by 20 ms

increments.

• This Time value is stored within a Preset.

• If the TapCtl parameter is set to Control, this parameter appears as Tempo and

displays and follows the current Tap Tempo BPM. Turning the PRESETS knob

adjusts by .1 BPM increments to allow ﬁne-tuning.

• Or, push the PRESETS knob while turning to adjust by full BPM values.

• If you stomp out your desired 1/4 note rhythm on the TA P footswitch, this will set

a new Tap Tempo, and FX3 models will then follow this new BPM value.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 80 81

No comments

Sennheiser HD400 User Manual Page 56