Sennheiser Pro1/Pro2 User Manual download pdf (Page 24)

Using the headset system

When the battery is about to run flat ...

... only the LED segment 1 lights up weakly or flashes (see page 9).

... the HEADSET LED  flashes red.

... you hear a low battery warning (three beeps)in the headset.

... you have several minutes of

battery re

serve.

When the battery is flat, the headset switches off.

If the headset is outside the range of the base station, it will switch

off after 30

minutes in order to conserve battery power.

Switching the headset on/off

If you place the headset into the base station, the headset automat-

ically switches to standby mode.

In standby mode, the power

consumption is very low and the radiated power is reduced to a

minimum. The HEADSET LED  lights up blue during charging.

Switching the headset on

왘 Press and hold the LINK button  for 5 seconds.

The HEADSET LED  flashes blue 3 times and the wireless link to the

base station is established (where re

quired). An ascending confirma-

tion beep is heard in the headset.

Switching the headset off

왘 Press and hold the LINK button  for 5 seconds.

The HEADSET LED  flashes red 3 times.

Establishing a wireless link between headset and

base station

To establish a wireless link between headset and base station:

왘 Press the LINK button  on the headset.

The link is established. The LINK LED  lights up blue and the

HEADSET LED  flashes blue.

To disconnect a wireless link between head

set and base station:

왘 Press the LINK button  on the headset.

The link is disconnected. The LINK LED  and the HEADSET LED 

go off.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

No comments

Sennheiser Pro1/Pro2 User Manual Page 24