Sennheiser MM450 Instruction Manual download pdf (Page 15)

Putting the MM 450-X into operation

14 | MM 450-X

Switching the MM 450-X on/off

Switching the MM 450-X on

왘 Press the Master button 햶 and keep it pressed until the LED 1

flashes blue. You hear an ascending beep.

– When switching the headset on for the first time, it will automatically

go into pairing mode.

The headset is waiting to be paired with a Bluetooth enabled device

(see page 12).

– When the headset is already paired with an audio source, the

Bluetooth connection is automatically established.

You hear an ascending beep and then you hear your audio source.

– When the headset is already paired with an audio source but the

audio source is switched off or out of range, the LED 1 flashes

blue.

The headset will try for 3 minutes to connect to one of the up to

8 previously paired audio sources. If this fails, the headset automati-

cally switches off after 60 minutes.

Switching the MM 450-X off

왘 Press the Master button 햶 and keep it pressed until the LED 1

flashes 3 times red.

You hear a descending beep. The Bluetooth connection is automatically

deactivated. The headset switches off.

WARNING

Danger of hearing damage!

Listening at high volume levels for long periods can lead to perma-

nent hearing defects.

왘 Before putting the headset on, set the volume to a low level.

왘 Do not continuously expose yourself to high volumes.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 28 29

No comments

Sennheiser MM450 Instruction Manual Page 15