Sennheiser EMP 2015 Instruction Manual download pdf (Page 19)











Connecting sound recording devices

You can connect sound recording devices (e.g. tape recorder, dictating

machine, etc.) to the RCA sockets (LINE OUT)  of the amplifer. The

connected device records the same signal that can be heard in the room

through the loudspeakers. If possible, connect the sound recording device

via its line input (LINE IN, REC. IN, AUX IN, TB IN or similar).

씰 Connect the RCA plugs of the sound recording devices to the RCA sockets

(LINE OUT)  at the rear of the EMP 2015. For correct connection of

the different audio devices, please refer to the diagrams at the left.

Adjusting the recording level

The recording level is independent of the setting of the volume controls 

and . It is, however, dependent on the setting of the line input sensitivity

control (LINE IN) . Control  adjusts the input level of the connected

audio device.

The recording level of the line output  can be adjusted from 0 to 700 mV

rms

(corresponds to minus infinite to up to 0 dBU).

1. The sound recording device is connected via its line input (LINE IN,

REC. IN, AUX IN, TB IN or similar):

씰 Turn control  clockwise as far as possible and adjust the input level

of the sound recording device.

2. The sound recording device is connected via its microphone input:

씰 Set the input level of the sound recording device to maximum and

use control  to adjust the recording level so that, during loud

passages, distortion is avoided.

Note:

If control  is turned counterclockwise as far as possible, no audio signal

will be available at the line output .

If you have connected two mono sound recording devices, the control adjusts

the recording level of both devices.

2 mono sound recording devices

1 stereo sound recording device

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

No comments

Sennheiser EMP 2015 Instruction Manual Page 19