Sennheiser W300 IEM User Manual download pdf (Page 17)

 Connect the two BNC connectors to the BNC sockets  on the twin

transmitter.

 Slide the twin transmitter into the 19’’ rack.

 Resecure the rack mount “ears”  to the rack .

 Connect the telescopic antennas to the BNC sockets .

 Pull the end caps to extend the telescopic antennas .

Changing the transmission power (SR 350 IEM G2 only)

With the SR 350 IEM G2 twin transmitter, you can choose between two

different transmission powers.

 Set the transmission power switch (RF POWER)  to the desired position.

Transmission power will change as follows:

ATTENTION! Danger of interference with other transmitters!

Depending on the selected transmission power and frequency,

you may have to apply for an approval from the respective

authority for a radio transmission licence, as you could interfere

with other transmitters. This approval will only be valid for the

approved transmission power. For detailed information, please

refer to the enclosed frequency data sheets and to the country-

specific frequency and transmission power overviews.

 Apply for an approval, should country-specific regulations

on frequency and/or transmission power usage require this.

ATTENTION! Danger of damage to the device!

Due to the high transmission power (100 mW) in the switch

position “STANDARD”, the optional AC 2 transmitter combiner

must not be used as this can cause damage to the devices.

 Use only the optional AC 3200 transmitter combiner (see

“Accessories and spare parts” on page 40).



Switch position Transmission power

LOW 15 mW

STANDARD 100 mW

ew300_350_IEM_INT.book Seite 15 Freitag, 7. März 2008 8:55 08

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 45 46

No comments

Sennheiser W300 IEM User Manual Page 17