Sennheiser Comfort calls Instruction Manual download pdf (Page 32)

Using the headset system

Pairing the headset to third party DECT GAP telephones

왘 Place the OfficeRunner™ headset at a maximum distance of 1 m from

the third party base station.

왘 Simultaneously press and hold the headset’s LINK button  and

AUDIO button  for 5 seconds.

The headset switches to setting mode/GAP pairing mode and the

HEADSET

LED  flashes blue/red.

왘 Set the third party base station to GAP pairing mode (see the

instruction manual of the third party base station).

The headset pairs to the third party base station. If pairing was

successful, the HEADSET LED

 goes off.

Pairing is not successful If pairing is not successful within 60 seconds, the OfficeRunner™ headset

switches to standby mode.

왘 For information on how to pair the headset to the third party base

station, refer to the instruction manual of the base station.

Charging an additional headset

If you wish to charge an additional headset (headset b) in the base station

while you are using your headset (headset a):

왘 Make sure that a wireless link is established between headset a and

base station (the LINK

LED  on the base station lights up blue).

왘 Place headset b into the base station.

Headset a can continue to connect to and disconnect from the base

station and its use is not restricted while headset b is being charged.

If you leave the DECT range

If you leave the DECT range during a call, the audio quality deteriorates.

When the link breaks down completely, you hear a descending sequence

of beeps in the headset and the LINK

LED  on the base station lights up

red.

To resume the call:

왘 Re-enter the DECT range of the headset system within 60 seconds.

As soon as the headset re-establishes the wireless link to the base

station, you hear a ring tone in the headset.

왘 Press the LINK button  on the headset to resume the call.

The standard code for OfficeRunner™ is “0000”.

If you are using a handset lifter/electronic hook switch or if your

softphone supports call control, the call will automatically be ended

seconds after leaving the DECT range.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 44 45

No comments

Sennheiser Comfort calls Instruction Manual Page 32