Sennheiser MM 400-X Operations Instructions download pdf (Page 19)

2/8/2012 19 Retsch GmbH

Storing the milling parameters

Storing or calling the preselected milling parameters can be

carried out only in the on mode.

After switching on the MM 400 “on” appears in the display L.

By pressing the button PROG the next programme position P1

to P9 can be obtained. After programme position P9 „on“

reappears in the display. In the PROG mode all buttons, apart

from PROG, START and STOP are blocked.

When the display shows on

the frequency M and time N are freely adjustable.

When the display shows P1 to P9

milling parameters can be stored and called

Start = the milling process is started with the selected

programme or the parameters freely selected under

„on“ .

Allocating the storage location

Press button PROG once or several times until the

required storage location P1-P9 has been reached.

Press SET button – all displays flash.

Set frequency M and time N.

The programming mode can be discontinued by pressing the

button PROG – the values are not stored.

Press SET button – the values are stored.

Flashing of the display stops, the adjustment interlock is

activated and the milling parameters are stored.

Operating hours display

If the buttons described below are pressed in the stand-by mode

the complete running time of the machine is shown in hours and

minutes.

Display operating hours :

Press buttons - "frequency 1/s" (- M) and SET

simultaneously and keep pressed.

“bS” appears in the display “memory”.

hhh hhh

Leave operating hours :

Press STOP button.

PROG

SET

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

No comments

Sennheiser MM 400-X Operations Instructions Page 19