Sennheiser TV Cables ADN User Manual download pdf (Page 21)

Putting the conference system into operation

Running the software on a

separate Windows PC

To run the “Conference Manager” software on a separate Windows PC, the PC must

meet the system requirements listed on page 50.

왘 Use a network cable (Cat5) to connect the Ethernet socket of the central

unit to the network interface of your PC.

왘 Install the “Conference Manager” software supplied on the CD ROM on your

connected PC (see page 51).

왘 Configure the network as described in the chapter “Preparing the Windows

version of the software for use” on page 50.

Switching the conference system on/off

To switch the conference system on:

왘 Set the on/off switch to position “I”.

The central unit switches on and its display panel lights up.

To switch the conference system off:

왘 Set the on/off switch to position “0”.

The central unit is switched off completely.

IN –– AUDIO –– OUT

PORT II PORT I

100-240V~

50/60Hz 240W

2x 52.8V 1.75A

You can also connect the PC and the central unit using a switch or similar.

If you have made changes to a configuration using the “Conference

Manager” software, you have to save these changes before switching the

central unit off (see page 69). All other settings of the central unit are

automatically saved.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 120 121

No comments

Sennheiser TV Cables ADN User Manual Page 21