Sennheiser EM 550 G2 Specifications download pdf (Page 12)

Putting the NET 1 into operation

Setting up the NET 1

Strong extraneous light may interfere with the data transfer via the infrared

interface. Therefore, position the NET 1 so as to avoid interference from

extraneous light.

Rack-mounting the NET 1

All NET 1 are delivered with the rack-mounting kit pre-assembled.

왘 Slide the NET 1 into the rack.

왘 Secure the NET 1 to the rack.

Fitting the device feet (“table top” use only)

When the NET 1 is not installed in a rack avoid the NET 1 device sliding around

and reduce the chance of damage to the device and to any surface on which

it is placed by fixing the four soft rubber self adhesive feet to the base of the

NET 1 device in the positions indicated.

Note:

Some furniture surfaces have been treated with varnish, polish or

synthetics which might cause stains when they come into contact with

other synthetics. Despite a thorough testing of the synthetics used by us,

we cannot rule out the possibility of staining.

왘 Ensure that the base of the device is clean and free from grease before

fitting the rubber feet.

왘 Fix the rubber feet to the base of the device by peeling off the backing

paper and fitting them as shown in the diagram on the left.

Danger of heat damage!

When installing the device in a closed or multi-rack assembly,

please consider that, during operation, the temperature

within the rack may rise significantly.

왘 Make sure not to affect the ventilation required for safe

operation or provide additional ventilation.

Danger of electric shock!

When installing the device in a closed or multi-rack assembly,

please note that intrinsically harmless leakage currents of the

individual devices may accumulate, thereby exceeding the

allowable limit value.

왘 Ground the rack via an additional ground connection.

CAUTION!

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

No comments

Sennheiser EM 550 G2 Specifications Page 12