Sennheiser EW 335 G3 Instruction Manual download pdf (Page 29)

Overview of the operating menus

Equalizer Changes the frequency response of the output signal

Auto Lock Activates/deactivates the automatic lock mode

Advanced Calls up the extended menu “Advanced Menu”

Exit Exits the operating menu and returns to the current standard display

“Easy Setup”

Reset List Releases all locked frequency presets and selects an unused frequency preset

Current List Selects an unused frequency preset

Scan New List Scans for unused receiving frequencies (frequency preset scan)

Exit Exits the submenu “Easy Setup” and returns to the main menu

Extended menu “Advanced Menu”

Tune Sets the receiving frequencies for the frequency banks “U1” to “U6”

Special function: Sets a channel and a receiving frequency for the frequency banks “U1” to

“U6”:

 Select this menu item and call it up by pressing the jog dial until the channel

selection appears.

Sync Settings Activates/deactivates the parameters to be transferred to the transmitters

Pilot Tone Activates/deactivates the pilot tone evaluation

Warnings Activates/deactivates the warning messages

LCD Contrast Adjusts the contrast of the display panel

Reset Resets the receiver

IP-Address Adjusts the IP address of the receiver

Software Revision Displays the current software revision

Exit Exits the extended menu “Advanced Menu” and returns to the main menu

Submenu “Sync Settings”

SKM Settings Activates/deactivates the parameters to be transferred to the SKM radio microphones

SK Settings Activates/deactivates the parameters to be transferred to the SK bodypack transmitters

Exit Exits the submenu “Sync Settings” and returns to the extended menu “Advanced Menu”

“SK Settings”/“SKM Settings”

Here you can activate/deactivate the transfer of the following transmitter parameters: Sensitivity, Auto Lock, Mute

Mode and RF Power (see page 28)

“Warnings”

Activates/deactivates warnings (color change and warning messages):

AF-Peak Audio overmodulation

Low RF-Signal RF signal is weak

RF-Mute RF signal is too weak or no RF signal

TX-Mute • Transmitter is muted or

• no pilot tone

RX-Mute Receiver is muted

Low Battery Charge status of the transmitter battery/the BA 2015 accupack is critical

Exit Exits the submenu “Warnings” and returns to the extended menu “Advanced Menu”

Display Function of the menu item

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

No comments

Sennheiser EW 335 G3 Instruction Manual Page 29