17
Changing parameters in a receiver
Before you change parameters:
“Remote Active” or “Remote Inactive” is displayed at the bottom of the
window. You can change parameters only when “Remote Active” is
displayed.
To change to the “Remote Active” mode:
왘 Close the “Properties” window.
왘 Click on “System” > “Remote Access”.in the menu bar.
The menu item is activated.
왘 Open the “Properties” window again.
To edit or update parameters:
Note:
y For parameters that you cannot change, the “Set” button is grayed
out. The parameters that you can change depend on the respective
receiver type.
y Specific information on the parameters can be found in the user
guides for the receivers.
왘 Click on the corresponding parameter.
The line for the parameter is highlighted in blue.
왘 Click on “Set”.
A new window opens.
왘 Enter the desired value.
왘 Confirm with “OK”.
The window closes; the new parameter is displayed.
Allocating frequencies to receivers
You can change the frequency for the receiver. To do so, you can:
y Select a predefined frequency in the receiver
or
y Program any frequency value within the frequency range applicable to
the receiver and then select this frequency.
Selecting a predefined
frequency
For “evolution wireless G2” series receivers
see page 18
For EM3532 dual receivers see page 19
Selecting a defined
frequency manually
For “evolution wireless G2” series receivers
see page 18
For EM3532 dual receivers see page 19
Comments to this Manuals