Sennheiser TV Cables ADN User Manual download pdf (Page 18)

Putting the conference system into operation

Setting up the conference system

Installing the cable holder

If you want to permanently install your conference

system in a room, use the

optional cable holders (see “Accessories” on page 108).

왘 Tilt the conference units as shown.

왘 Hold the conference units with one hand so that the microp

hone does not rest

on the table.

왘 Insert the cable holder as shown.

At this point, the cable holder is not yet fixed with screws. You first have to

connect the conference units as described in the following chapter.

Connecting the conference units to the central unit

You can connect up to 15 conference units to each of the central unit’s connection

sockets PORT II or PORT I . The maximum number of conference units that can

be used in one cable string depends on the ov

erall cable length connected to a port

(see page 13).

The following describes the pr

ocedure for one cable string. If necessary, repeat

these steps for a second cable string.

왘 Place the conference units at the corresponding seats.

왘 Put out a sufficient number of system cables in the re

quired lengths (se

“Accessories” on page 108).

왘 If necessary, calculate the maximum length

of the

cable string in order to

ensure that all conference units connected in the string are supplied with a

voltage of at least 35 V (see page 13).

IN OUT



IN –– AUDIO –– OUT

PORT II PORT I

100-240V~

50/60Hz 240W

2x 52.8V 1.75A

8 9

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 120 121

No comments

Sennheiser TV Cables ADN User Manual Page 18