Sennheiser Microphone SDC 8200 User Manual download pdf (Page 28)

Operating the components of the SDC 8200 system

Turning interconnected SDC 8200 CU central units on/off

When turning on a conference and interpretation system with several

SDC 8200 CU central units, it is important that the central units are turned

on in the correct order.

왘 First turn on the “master” central unit.

왘 Then turn on the “slave” central units in the order in which they are

connected to the “master”.

To turn a central unit on:

왘 Set the POWER switch  to position “I”.

The consoles which are powered via this central unit are ready for oper-

ation as soon as they are initialized.

The start display is shown on the LC display of this central unit.

Note!

It is, however, possible to simultaneously turn on interconnected cen-

tral units via a switchable multiple socket.

To turn a central unit off:

왘 Set the POWER switch  to position “0”.

The display goes off. All consoles which were powered via this central

unit are also turned off.

Note!

The central units are not disconnected from the mains when they are

turned off. To disconnect the central units from the mains, pull their

mains plugs out of the wall outlets.

Operating the delegate units

Taking the floor / Making a request to speak

In order to take the floor or make a request to speak, you have to press the

microphone key . Depending on the conference mode chosen (1. to

10., see following section), you can either take the floor immediately or

you have to wait until your microphone is turned on.



>Volume =

P1 P2 P3 P4 P5 P6





1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 127 128

No comments

Sennheiser Microphone SDC 8200 User Manual Page 28