Sennheiser Microphone SDC 8200 User Manual download pdf (Page 86)

Configuring the SDC 8200 system

As soon as the initialization of a conference console is accepted by the

central unit, the red signal light ring of the console goes off.

왘 Press the ENTER key to save this configuration.

Loading the factory-preset default configuration for the conference sys-

tem

If necessary, you can load the factory-preset default configuration for the

conference system.

Note!

Loading the factory-preset default configuration will delete all setting

of your current configuration! Your conference system then has to be

re-configured to become operational!

To load the factory-preset default configuration for the conference sys-

tem:

왘 From the central unit’s operating menu, choose “

Conference”,

“

Initialise Units” and “Load Defaults” one after the other.

The text “

Configuration will be overwritten. Continue?” is

shown on the display.

왘 Press the ENTER key to replace your current configuration by the fac-

tory-preset default configuration.

Adding a conference console to an already existing configuration

To add newly connected conference consoles to an already existing config-

uration:

왘 From the central unit’s operating menu, choose “

Conference”,

“

Initialise Units” and “Manual Init” one after the other.

The red signal light rings  and the “Microphone active” LEDs  on all

conference consoles start flashing.

왘 Choose “

Add Unit”.

Only the signal light rings of the conference consoles not yet initialized

remain flashing.

왘 Press the microphone key  of the conference consoles which you

want to add to your configuration.

As soon as the initialization of a conference console is accepted by the

central unit, the signal light ring of the console goes off.

Removing a conference console from an already existing configuration

To remove a conference console from an already existing configuration:

왘 From the central unit’s operating menu, choose “

Conference”,

“

Initialise Units” and “Manual Init” one after the other.

The red signal light rings  and the “Microphone active” LEDs  on all

conference consoles start flashing.

왘 Choose “

Delete Unit”.

The text “

Mic. Number = 00” is shown on the display.

Initialise Units

3 Load Defaults

Initialise Units

1 Manual Init

Manual Init

2 Add Unit

Initialise Units

1 Manual Init

Manual Init

3 Delete Unit

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 127 128

Comments to this Manuals

No comments

Sennheiser Microphone SDC 8200 User Manual Page 86

Comments to this Manuals

Related products and manuals for Musical Equipment Sennheiser Microphone SDC 8200